Interiors · Kitchens

Standard kitchen dimensions, and how to measure properly

Some dimensions have become standard because they suit average reach and height. But standard does not mean right for every household — this article says where to follow the convention and where to measure the person who actually cooks.

The basic dimensions

ItemUsual range
Base unit height including worktop81 – 86 cm
Base unit depth56 – 60 cm
Wall unit height70 – 90 cm
Wall unit depth33 – 35 cm
Clearance, worktop to underside of wall units60 – 70 cm
Island heightsame as base units: 81 – 86 cm
Breakfast bar height (tall stools)100 – 110 cm
Gangway between facing runs90 – 120 cm
Island to the main run90 – 120 cm

Worktop height — set this from the cook, not the standard

This dimension affects daily cooking more than any other, and it is where we suggest abandoning the convention.

How to measure: the main cook stands straight, arms at their sides, elbows bent to 90 degrees. Measure from the floor to the palm. The worktop should sit roughly 10 – 15 cm below that figure.

Someone 1.50 m tall and someone 1.70 m tall produce results a good ten centimetres apart. A single figure of 82 cm means one of them has a sore back every day.

Too high and the shoulders lift when chopping; too low and the back bends. Either only becomes apparent after months of use, by which point it cannot be changed.

Wall unit clearance

60 – 70 cm above the worktop is the usual range. The trade-off:

  • Lower (60 cm): easier reach, suits shorter cooks. But heads meet cupboards when working at the worktop, and usable worktop shrinks.
  • Higher (70 cm): open worktop, lighter appearance. But the top shelf needs a stool — and becomes the shelf where things go to be forgotten.

A sensible compromise: hang at 65 cm and plan the top shelf as seasonal storage from the start, rather than pretending it is convenient.

Islands: three numbers

Distance to the main run

Minimum 90 cm; comfortable is 100 – 120 cm. The most important island dimension and the most common mistake: a handsome island set too close, so the oven door or a drawer fouls it.

Where two people cook together, or a fridge door opens towards the island, allow 110 – 120 cm.

Height

Same as the base units (81 – 86 cm) for food preparation. If the island doubles as a breakfast bar with tall stools, that section goes to 100 – 110 cm. Two levels work well but take more space and require the stone cut in two tiers.

Size

Below about 120 × 60 cm an island does little. But it only makes sense where the kitchen is at least 3.5 m wide — narrower and the island consumes the gangway, where a longer run would serve better.

The work triangle

The three most-used points are the hob, the sink and the fridge. Joined into a triangle:

  • Each side between 1.2 and 2.7 m.
  • The three sides totalling under 8 m.
  • No main circulation route crossing the triangle. This is the one most often ignored: a handsome kitchen where everyone heading to the yard walks between cook and hob.

And a clearance rarely mentioned: allow at least 40 cm of worktop on each side of the hob, for a pan just lifted off. A hob tight into a corner is a recurring design fault.

Measuring an L-shaped kitchen

One centimetre of error throws the whole run out, because units are set end to end. The sequence:

  1. Measure each leg at three heights — at the floor, mid-height, and at wall-unit level. Walls are rarely true; take the smallest figure.
  2. Measure the ceiling height at both ends, in case floor or ceiling falls away.
  3. Check the corner is square by measuring the diagonals. If it is not, a gap must be allowed and covered with a scribe.
  4. Mark every service: hot and cold supplies, waste, sockets, switches, extract duct, gas valve, service riser, window and cill.
  5. Measure from the corner to each of them — not simply "there is a socket here".
The corner is where L-shaped kitchens go wrong. Two doors meeting at the corner can foul each other when opened together, and the corner cabinet is where things disappear. Ask how the corner is handled: a carousel, a pull-out corner unit, or simply left empty. Each has its price, and the cheapest is the hardest to use.

What must be fixed before plastering

  • Socket positions and heights — microwave, dishwasher, induction hob, extractor
  • Supply and waste for the sink and dishwasher
  • Extract ducting to outside: diameter and the position of the wall penetration
  • Gas valve position, if gas is used
  • Finished floor level, for the plinth

Settle these late and the walls are chased open again after plastering and painting.

How Tropicity works

We measure on site before cutting rather than working from old drawings, because walls as built rarely match walls as drawn. We ask who does most of the cooking before fixing the worktop height, rather than defaulting to 82 cm.

Because Tropicity carries both the construction and the interiors, the services left ready for the kitchen are fixed on the same drawings as the architecture.

See choosing a kitchen layout, cabinet materials, or a kitchen we built.

Send your kitchen plan

Free preliminary estimate

Get our company profile and a budget range within 48 hours

Tell us where your project is and what you plan to build. A Tropicity engineer replies within one working day and arranges a site visit in Ho Chi Minh City and the southern provinces.

  • One contract, one estimate, one point of contact
  • A structural engineer visits your site
  • English-speaking contact; no marketing emails

Why the site address? Planning rules, building density and truck access change the price. Without the address an estimate is only a generic figure.

Please enter your name.
Please enter a valid email.
Please select a project type.
Please enter the project location.

Urgent: call +84 937 989 858

Zalo